Equip USB 2.0 Frontpanel 3.5" + Card Reader 30plus Manual download pdf (Page 4)

www.equip-info.net

6.0 How to Install Your Card Reader to drive Bay

1. Turn your computer off and disconnect the power cord.

2. Remove the cover of your computer.

(Refer to your computers hardware reference manual and follow the instructions to removing the cover)

3. Remove 3.5inch plastic cover on your PCs front panel.

4. Put this device with all cables into the 3.5inch drive bay.

5. Mount device firmly in both tracks of drive bay by four screws (ISO 3ö*4mm).

6. Select a free PCI slot and remove the metal bracket cover.

7. Put the media cables out the chassis, which are all for the outside jack connection.

8. Connect external audio jacks.

9. Connect inner on-board USB and Firewire pass through connector

that is a standard ten pin male header on your motherboard.

(Please refer to the following USB pin assignment description and check your computers on-board pin

assignment that is the same definition. You can refer to your computers hardware reference manual.)

10. When you complete all installation, please re-check all cables connection again.

Because incorrect connection will result damage to the exist device.

11. Recover your computer and apply the power cord again.

www.equip-info.net

Manual_Page 4

 Electrostatic discharge can damaged electronic components.

Be sure you are properly grounded before beging any procedure.

 You can touch a metal part of the computers chassis or power supply unit to

discharge any static charge that may have built up inside your body.

CAUTION

1 2 3 4 5 6 7 8 9 ... 28 29

No comments

Equip USB 2.0 Frontpanel 3.5" + Card Reader 30plus Manual Page 4